Daniel in cursive
"Daniel" takes 3 strokes to write in cursive: the letters in one flow, then dot the i. Follow the letter-by-letter steps below and print the free worksheet to trace and copy it.
Free Daniel worksheet
Daniel in cursive practice sheet
1 page · US Letter, prints on A4 · free
"Daniel" on three-line guides in two sizes: a solid model, dashed copies to trace, and blank lines to write it on your own.
Want it with other words or a different line size? Use the worksheet generator.
How to write Daniel in cursive
- Start with a capital D (downcurve, loop, curve down, curve up, curve right). Start just below the topline. Curve down and around to the baseline and make a small loop at the bottom left.
- Lift the pencil after the D, then write the a (downcurve, undercurve, slant, undercurve): a small oval closed at the midline, then a slant down and an undercurve out.
- Swing up into the n (overcurve, slant, overcurve, slant, undercurve): two rounded humps made with overcurves.
- Swing up into the i (undercurve, slant, undercurve; dot): a short undercurve and slant, with the dot added after the word is finished.
- Swing up into the e (undercurve, loop, slant, undercurve): a small loop between the baseline and the midline.
- Swing up into the l (undercurve, loop, slant, undercurve): one tall loop, the simplest tall letter.
- After the word, dot the i.
How the letters in Daniel connect
- Da The capital D stands alone. Lift the pencil and start the a fresh on the baseline.
- an a to n: an undercurve join. The exit stroke of the a swings up into the n.
- ni n to i: an undercurve join. The exit stroke of the n swings up into the i.
- ie i to e: an undercurve join. The exit stroke of the i swings up into the e.
- el e to l: an undercurve join. The exit stroke of the e swings up into the l.
The letters in Daniel
Daniel questions
How many strokes does it take to write Daniel in cursive?
3 strokes: 2 continuous runs of letters, because a capital that stands alone forces a pencil lift, then dot the i. Inside a word the pencil stays on the paper; dots and crosses are added once the word is finished.
Are all the letters in Daniel connected?
Yes. Every join in "Daniel" is a baseline join: each letter ends with an upward exit stroke on the baseline and the next letter starts from it. There are no bridge letters (b, o, v, w) in this word.
Is Daniel capitalized in cursive?
Yes. Daniel is a name, so it always starts with a capital D. The capital D stands alone: lift the pencil after it.
Is Daniel an easy word to write in cursive?
Yes. None of its letters (d, a, n, i, e, l) is among the tricky ones (r, s, f, k, b), which makes "Daniel" a good early practice word.